Replacing fog lamp bulbs
1. Make sure the fog lamp switch is in the off position.
2. From underneath the vehicle, partially remove the tire splash shield by removing four drive screws.
After removing to allow free access to the front fog lamp bulb and electrical wire harness, the splash shield flap can be repositioned.
3. Rotate the harness/bulb assembly counterclockwise to remove from the fog lamp.
4. Carefully disconnect the bulb from the harness assembly via the two snap clips.
Install the new bulb in reverse order.
See also:
Automatic disarming
The vehicle is disarmed immediately after the ignition is turned to the on
position.
The theft indicator will illuminate for three seconds and then go out. If
the theft indicator stays on for an ...
Speed control
With speed control set, you can maintain a set speed without keeping
your foot on the accelerator pedal.
WARNING: Do not use the speed control in heavy traffic or on
roads that are winding, slipp ...
Second generation (2003–2006)
The Navigator was updated in 2003, along with the Ford Expedition, on the new
Ford U platform. The interior was also substantially revised to bring it up to
the level expected by luxury buyers. So ...