Sand

Sand  - Driving on slippery surfaces with AWD vehicles - All-wheel drive (awd) system (if equipped) - Driving - Lincoln MKZ Owners Manual - Lincoln MKZ

When driving over sand, try to keep all four wheels on the most solid area of the trail. Avoid reducing the tire pressures but shift to a lower gear and drive steadily through the terrain. Apply the accelerator slowly and avoid spinning the wheels.

When driving at slow speeds in deep sand under high outside temperatures, use a low gear or (L) when possible. L (Low) gear operation will maximize the engine and transmission cooling capability.

Under severe operating conditions, the A/C may cycle on and off to protect overheating of the engine.

Avoid excessive speed because vehicle momentum can work against you and cause the vehicle to become stuck to the point that assistance may be required from another vehicle. Remember, you may be able to back out the way you came if you proceed with caution.

    See also:

    Changing tires with a TPMS
    Each road tire is equipped with a tire pressure sensor located inside the tire/wheel cavity. The pressure sensor is attached to the valve stem. The pressure sensor is covered by the tire and ...

    Reporting safety defects (U.S. only)
    If you believe that your vehicle has a defect which could cause a crash or could cause injury or death, you should immediately inform the National Highway Traffic Safety Administration (NHTS ...

    Replacing backup lamp/supplemental tail lamp
    The backup lamp and supplemental tail lamps are located in the trunk lid. Follow the same steps to replace either lamp. 1. Make sure the headlamp switch is in the off position and open trunk ...