Removing the spare tire and jack

Removing the spare tire and jack - Stopping and securing the vehicle - Changing the tires - Roadside Emergencies - Lincoln MKZ Owners Manual - Lincoln MKZ

1. Remove the carpeted load floor

1. Remove the carpeted load floor panel located in the rear of the vehicle and remove the lug wrench and long bolt from the tool bag.

2. Remove the bolt securing the spare tire using the lug wrench, then lift and remove the spare tire from the trunk.

3. Remove the jack retention bolt by turning it counterclockwise and remove the jack from the vehicle.

    See also:

    Gate Operator & Canadian Programming
    During programming, your hand-held transmitter may automatically stop transmitting — not allowing enough time for HomeLink to accept the signal from the hand-held transmitter. After compl ...

    Checking automatic transmission fluid at normal operating temperature (140°F-158°F [60°C-70°C])
    Automatic transmission fluid expands when warmed. To obtain an accurate fluid check, drive the vehicle until it is warmed up (approximately 20 miles [30 km]) until the engine coolant gauge indic ...

    Fixed code programming
    Note: It may be helpful to have another person assist you in programming the transmitter. To program units with fixed code DIP switches, you will need the garage door hand-held transmitter, ...