Removing the jumper cables

Removing the jumper cables - Jump starting - Roadside Emergencies - Lincoln MKZ Owners Manual - Lincoln MKZ

Remove the jumper cables in the reverse order that they were connected.

Note: In the illustration, the vehicle on the bottom is used to designate the assisting (boosting) battery.

1. Remove the jumper cable from

1. Remove the jumper cable from the ground metal surface.

2. Remove the jumper cable on the negative (-) terminal of the booster vehicle’s battery.

3. Remove the jumper cable from the positive (+) terminal of the booster vehicle’s battery.

4. Remove the jumper cable from the positive (+) terminal of the disabled vehicle’s battery.

After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions.

    See also:

    How to reprogram your integrated keyhead transmitters (IKTs)
    To program a new integrated keyhead transmitter yourself, refer to Programming spare keys in the SecuriLock passive anti-theft system section of this chapter. Note: At least two IKTs are required ...

    Understanding your tire pressure monitoring system (TPMS)
    The tire pressure monitoring system measures pressure in your four road tires and sends the tire pressure readings to your vehicle. The low tire pressure warning light will turn on if the tire pre ...

    Power tilt/telescope steering column
    The steering column can be adjusted manually by moving the four-way rocker adjustment control located below the turn signal/wiper control stalk. Hold the control to adjust. The telescope ...