APA finished

When active park assist has completed the automated steering, the message center displays ACTIVE PARK FINISHED followed by a chime.

The driver is responsible to assess and correct as necessary the final parking position and put the vehicle in P (Park).
The system can also be deactivated at any time by the following:
• Pressing the APA control switch
• Grabbing the steering wheel
• Exceeding a vehicle speed of 18 mph (30 km/h) for 30 seconds during
active park searching
• Exceeding a vehicle speed of 6 mph (10 km/h) during automatic
steering
• Deactivating the AdvanceTrac system or the system has activated on
a slippery or loose surface
• ABS activation or failure
• Any door (except the driver’s door) opens
• Something touching the steering wheel
If a fault is present in the system, the message ACTIVE PARK FAULT will be displayed followed by a chime. Contact an authorized dealer to have your vehicle serviced.
The system should not be used if:
• a foreign object (i.e. bike rack, trailer, etc.) is attached to the front
or
rear of the vehicle or at another location close to the sensors.
• the front bumper or side sensors are damaged (i.e. in a collision) or
obstructed by a foreign object (i.e. front bumper cover).
• a mini-spare tire is used.
See also:
Erasing HomeLink buttons
To erase the three programmed
buttons (individual buttons cannot
be erased):
• Press and hold the two outer
HomeLink buttons until the
indicator light begins to
flash-after 20 seconds. Re ...
Setting the clock
CLOCK: Press to set the clock. The display will read SET TIME. Use the
memory preset numbers (0–9) to enter in the desired time– hours and
minutes and press OK. The clock will then begin from that ...
What you should know about fail-safe cooling
If the engine coolant supply is depleted, this feature allows the vehicle to
be driven temporarily before incremental component damage is incurred.
The “fail-safe” distance depends on ambient tempe ...
