Replacing the battery

Replacing the battery  - Remote entry system - Locks and Security - Lincoln MKX Owners Manual - Lincoln MKX

The intelligent access key (IA key) uses one coin type three-volt lithium battery CR2032 or equivalent.

To replace the battery:

1. Remove the backup key from the transmitter, then twist a thin coin in the slot hidden behind the backup key slot to remove the battery cover.

Note: Do not wipe off any grease on the battery terminals or on the back surface of the circuit board.

2. Remove the old battery.

2. Remove the old battery.

Note: Please refer to local regulations when disposing of transmitter batteries.

3. Insert the new battery. Refer to the instructions inside the IA key for the correct orientation of the battery. Press the battery down to ensure that the battery is fully seated in the battery housing cavity.
4. Snap the battery cover back onto the transmitter and install the backup key.

Note: Replacement of the battery will not cause the IKT or IA key to

Note: Replacement of the battery will not cause the IKT or IA key to become de-programmed from your vehicle. They should operate normally after battery replacement.

    See also:

    Fuel filter
    Your vehicle is equipped with a lifetime fuel filter that is integrated with the fuel tank. Regular maintenance or replacement is not needed. ...

    Engine shield
    Some vehicles may be equipped with an aero-shield under the engine. This shield needs to be removed for service, including oil and filter changes. It is secured with four quick release fastener ...

    Overview
    The Lincoln Navigator serves as Lincoln's full-sized luxury SUV. The Navigator shares the same platform with the lesser Ford Expedition full-size SUV. Introduced in 1998, the Navigator has proven ...