Turning the engine off after using remote start

• Press
one time. The parking
lamps will turn off.
You may have to be closer to the vehicle than when starting due to ground reflection and the added noise of the running engine.
You can disable or enable the remote start system through the message center. Refer to Message center in the Instrument Cluster chapter.
See also:
Erasing the function button codes
Note: You cannot erase individual
buttons.
1. Press and hold the outer two
function buttons simultaneously for
approximately 20 seconds until the
LED lamps above the buttons flash
rapid ...
Starting the engine
1. Turn the key to 3 (on) without
turning the key to 4 (start). If there
is difficulty in turning the key,
rotate the steering wheel until the
key turns freely. This condition may
occur wh ...
Fuses
If electrical components in the
vehicle are not working, a fuse may
have blown. Blown fuses are
identified by a broken wire within
the fuse. Check the appropriate
fuses before replacing an ...
