BLIS -CTA fault operation

BLIS -CTA fault operation - Blind spot information system (blis ) with cross traffic alert (cta) (if equipped) - Driving - Lincoln MKZ Owners Manual - Lincoln MKZ

If the BLIS -CTA senses a fault on either the left or right sensor, the BLIS alert indicator will go ON and remain ON and the message center will display BLIND SPOT SYSTEM FAULT or CROSS TRAFFIC SYSTEM FAULT. For faults that may cause the associated left or right alert indicator not to illuminate, only the message center faults will occur.

    See also:

    Removing the jumper cables
    Remove the jumper cables in the reverse order that they were connected. Note: In the illustration, the vehicle on the bottom is used to designate the assisting (boosting) battery. 1. Remove th ...

    Arming the system
    The system is ready to arm whenever the ignition is off. To arm the system, do one of the following: • Press the control on the remote entry transmitter. Note: If you press the control t ...

    Information contained on the tire sidewall
    Both U.S. and Canada Federal regulations require tire manufacturers to place standardized information on the sidewall of all tires. This information identifies and describes the fundamental charac ...