Using the power lumbar support


The power lumbar control is located on the outboard side of the seat.
Press one side of the control to adjust firmness.
Press the other side of the control to adjust softness.
See also:
BLIS and/or CTA on/off and disable operation
The BLIS and/or the CTA can be turned off via the message center. If
either the BLIS and/or the CTA is turned off, the systems will
automatically turn back on at the next ignition key cycle. When ...
Replacing headlamp bulbs
High beam/low beam bulb replacement
For driver side replacement of the high beam/low beam bulbs, do the
following:
1. Make sure the headlamp switch is in the off position, then open the
hood.
2 ...
Wheel lug nut torque specifications
Retighten the lug nuts to the specified torque within 100 miles (160 km)
after any wheel disturbance (rotation, flat tire, wheel removal, etc.).
WARNING: When a wheel is installed, always remove ...
