Activating/deactivating collision warning system

Activating/deactivating collision warning system  - Collision warning system (if equipped) - Driving - Lincoln MKS Owners Manual - Lincoln MKS

To turn the warning system and/or chime on or off and set the warning sensitivity <– –>, refer to Message center in the Instrument Cluster chapter.

Note: If the system cannot be turned off in a MyKey equipped vehicle, refer to MyKey in the Locks and Security chapter for more information.

Note: If collision warnings are perceived as being too frequent or disturbing then the warning sensitivity can be reduced, though the manufacturer recommends using the highest sensitivity setting where possible. Setting lower sensitivity would lead to fewer and later system warnings. Refer to the Message center in the Instrument Cluster chapter for instructions on reducing the sensitivity.

    See also:

    Aiming the headlamps
    The headlamps on your vehicle are properly aimed at the assembly plant. If your vehicle has been in an accident, the alignment of your headlamps should be checked by your authorized dealer. ...

    Fuses
    If electrical components in the vehicle are not working, a fuse may have blown. Blown fuses are identified by a broken wire within the fuse. Check the appropriate fuses before replacing an ...

    Trailer tow connector (vehicles equipped with a Class II trailertow/prep package)
    The trailer tow connector is located under the rear bumper, on the driver’s side of the vehicle. Refer to the following chart for information regarding the factory-equipped trailer tow connecto ...