Replacing headlamp bulbs

Replacing headlamp bulbs  - Replacing exterior bulbs - Bulb replacement - Lights - Lincoln MKZ Owners Manual - Lincoln MKZ

High beam/low beam bulb replacement

For driver side replacement of the high beam/low beam bulbs, do the following:

1. Make sure the headlamp switch is in the off position, then open the hood.

2. Reach over the front bolster and remove the rubber bulb access cover from the headlamp housing.

3. Remove the bulb socket by rotating it counterclockwise, then pull it straight out of the lamp assembly.

4. Disconnect the electrical connector.

For passenger side replacement of the high beam bulb, see your authorized dealer.

For passenger side replacement of the low beam bulb, do the following:

1. Turn the steering wheel all the way to the left.

1. Turn the steering wheel all the way to the left.

2. Remove the press pins located in the wheel well and pull the tire splash shield back.

3. Reaching through the wheel well, remove the rubber headlamp bulb

3. Reaching through the wheel well, remove the rubber headlamp bulb access cover.

4. Rotate the headlamp bulb counterclockwise and remove the headlamp bulb.

5. Disconnect the electrical connector.

    See also:

    Octane Recommendations
    “Regular” unleaded gasoline with a pump (R+M)/2 octane rating of 87 is recommended. Some stations offer fuels posted as “Regular” with an octane rating below 87, particularly in high altit ...

    Preparing to tow
    Use the proper equipment for towing a trailer and make sure it is properly attached to your vehicle. Contact your authorized dealer or a reliable trailer dealer as soon as possible if you require ...

    Information about uniform tire quality grading
    Tire Quality Grades apply to new pneumatic passenger car tires. The Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For ...