Sounding a panic alarm

Press
to activate the alarm.
The horn will sound and the turn lamps will
flash for a maximum of three minutes. Press again or turn the ignition to the
on position to deactivate, or wait for the alarm to time out in three minutes.
Note: The panic alarm will only operate when the ignition is in the off position.
See also:
How to use the engine block heater
Ensure the receptacle terminals are clean and dry prior to use. To clean
them, use a dry cloth.
Depending on the type of factory installed equipment, your engine block
heater will use .4 to 1.0 k ...
U.S. Dot tire identification number (TIN)
Both U.S. and Canada Federal regulations require tire manufacturers to
place standardized information on the sidewall of all tires. This
information identifies and describes the fundamental charac ...
Installing child safety seats with combination lap and shoulderbelts
Check to make sure the child seat is properly secured before each use.
Children 12 and under should be properly restrained in a rear seating position
whenever possible. If all children cannot be ...
