See also:

Gate Operator & Canadian Programming
During programming, your hand-held transmitter may automatically stop transmitting — not allowing enough time for HomeLink to accept the signal from the hand-held transmitter. After compl ...

Removing the jumper cables
Remove the jumper cables in the reverse order that they were connected. Note: In the illustration, the vehicle on the bottom is used to designate the assisting (boosting) battery. 1. Remove ...

Changing the set speed
There are three ways to change the set speed: • Accelerate or brake to the desired speed and press and release the SET + or SET – control • Increase or decrease the speed by holding eit ...