Reprogramming a single HomeLink button

Reprogramming a single HomeLink button  - HomeLink Wireless Control System - Universal garage door - Driver Controls - Lincoln MKS Owners Manual - Lincoln MKS

To program a device to HomeLink using a HomeLink button previously trained, follow these steps:

1. Press and hold the desired HomeLink button. Do NOT release the button.
2. The indicator light will begin to flash after 20 seconds. Without releasing the HomeLink button, follow Step 1 in the Programming section.

For questions or comments, contact HomeLink at www.homelink.com or 1–800–355–3515.

    See also:

    Autolamp control
    The autolamp system provides light sensitive automatic on-off control of the exterior lights normally controlled by the headlamp control. • To turn autolamps on, rotate the control to . • ...

    ACC Not Available
    Several conditions exist which can cause ACC to deactivate or prevent ACC from activating when requested. These conditions include: • The sensor is blocked, refer to Blocked sensor in this sectio ...

    Hazard flasher control
    The hazard flasher control is located on the instrument panel above the climate controls and below the audio controls. The hazard flashers will operate when the ignition is in any position o ...