Unlocking the doors/two-stage unlock
Press and release to unlock all
the doors.
Note: The interior lamps and parking lamps will illuminate.
The remote entry system activates the illuminated entry feature; this feature turns on the lamps for 25 seconds or until the ignition is turned on.
The battery saver feature will turn off the interior lamps 10 minutes after the ignition is turned off.
If two-stage unlocking is enabled:
1. Press and release to unlock
the driver’s door.
Note: The interior lamps and parking lamps will illuminate.
2. Press and release again
within three seconds to unlock all the
doors.
Two-stage unlocking may be disabled or enabled by simultaneously
pressing the and
controls on the transmitter for
four seconds
(disabling two stage unlock allows all vehicle doors to unlock
simultaneously). The parking lamps will illuminate twice to indicate that
two-stage unlock was enabled or disabled. The unlocking mode will be
applied to remote entry, keyless entry and intelligent access.
Two-stage unlocking may also be disabled or enabled through the message center if this is an available message center option or by your authorized dealer. Refer to Message center in the Instrument Cluster chapter.
When two-stage unlocking is disabled, intelligent access at the driver’s door results in an unlock of all doors (not just the driver door).
See also:
Using the power lumbar support
The lumbar control is located on the side of the seat cushion.
Press the front of the control to
adjust firmness.
Press the rear of the control to
adjust softness.
Press the top of the co ...
Combination lap and shoulder belts
1. Insert the belt tongue into the
proper buckle (the buckle closest to
the direction the tongue is coming
from) until you hear a snap and feel
it latch. Make sure the tongue is
securely fas ...
Push button start system
Your vehicle is equipped with the
push button start system. You can
start your vehicle by pressing the
start button in combination with the
brake pedal rather than using a key.
The start bu ...