Safety belt extension assembly
If the safety belt is too short when fully extended, a safety belt extension assembly can be obtained from an authorized dealer.
Use only extensions manufactured by the same supplier as the safety belt. Manufacturer identification is located at the end of the webbing on the label. Also, use the safety belt extension only if the safety belt is too short for you when fully extended.
WARNING: Do not use extensions to change the fit of the shoulder belt across the torso.
See also:
Daytime running lamps (DRL) (if equipped)
To activate:
• the ignition must be in the on position,
• the headlamp control must be in the off, autolamps or parking lamp
position and
• the transmission must be out of the P (Park) positi ...
Location of the tire label
You will find a Tire Label containing tire inflation pressure by tire size
and other important information located on the B-Pillar or the edge of
the driver’s door. Refer to the payload descriptio ...
Using the power lumbar support
The lumbar control is located on the side of the seat cushion.
Press the front of the control to
adjust firmness.
Press the rear of the control to
adjust softness.
Press the top of the co ...