Anti-scan feature

If the wrong code has been entered seven times (35 consecutive button presses), the keypad will go into an anti-scan mode. This mode disables the keypad for one minute and the keypad lamp will flash.
The anti-scan feature will turn off after:
• one minute of keypad inactivity.
• pressing the
control on the
transmitter.
• the ignition is turned on.
• unlocking the vehicle using intelligent access.
See also:
Driving through water
If driving through deep or standing
water is unavoidable, proceed very
slowly. Never drive through water
that is higher than the bottom of
the wheel rims (for cars) or the
bottom of the hubs ...
Children and airbags
Children must always be properly
restrained. Accident statistics
suggest that children are safer when
properly restrained in the rear
seating positions than in the front
seating position. ...
BLIS and/or CTA on/off and disable operation
The BLIS and/or the CTA can be turned off via the message center. If
either the BLIS and/or the CTA is turned off, the systems will
automatically turn back on at the next ignition key cycle. When ...
