Safety belt extension assembly
If the safety belt is too short when fully extended, a safety belt extension assembly can be obtained from an authorized dealer.
Use only extensions manufactured by the same supplier as the safety belt. Manufacturer identification is located at the end of the webbing on the label. Also, use the safety belt extension only if the safety belt is too short for you when fully extended.
WARNING: Do not use extensions to change the fit of the shoulder belt across the torso.
See also:
BLIS and/or CTA on/off and disable operation
The BLIS and/or the CTA can be turned off via the message center. If
either the BLIS and/or the CTA is turned off, the systems will
automatically turn back on at the next ignition key cycle. When ...
Check MyKey system status
The vehicle’s message center information menu will provide the status of
the following MyKey parameters:
• MYKEY MILES (km) — This odometer only tracks distance when a
MyKey is used. If distanc ...
Rear window defroster
The rear defroster control is located on the climate control panel and
works to clear the rear window of fog and thin ice.
The ignition must be on to operate the rear window defroster.
The rea ...