BLIS and/or CTA on/off and disable operation
The BLIS and/or the CTA can be turned off via the message center. If either the BLIS and/or the CTA is turned off, the systems will automatically turn back on at the next ignition key cycle. When either the BLIS and/or the CTA is turned off, the message center displays BLIND SPOT SYS OFF and/or CTA SYSTEM OFF. When the BLIS and/or the CTA system is off, the driver will not receive alerts. Refer to Message center in the Instrument Cluster chapter.
Note: If the system cannot be turned off, refer to MyKey in the Locks and Security chapter for more information.
The BLIS and/or the CTA can be disabled permanently even after an ignition key cycle. This must be done by your authorized dealer. Note:
Once either of the systems are disabled, enabling must also be performed at the dealership. When disabled, the message center will display BLIND SPOT DISABLED and/or CTA DISABLED.
See also:
Brake fluid
The fluid level will drop slowly as
the brakes wear, and will rise when
the brake components are replaced.
Fluid levels between the MIN and
MAX lines are within the normal
operating range; ...
Keyless entry keypad procedure
1. Turn the ignition to the off
position.
2. Close all the doors.
3. Enter factory–set 5–digit entry
code.
4. Press and hold the 3 • 4. While holding the 3 • 4 press the 7 • 8.
5. Release ...
Driving on hilly or sloping terrain
Although natural obstacles may make it necessary to travel diagonally up
or down a hill or steep incline, you should always try to drive straight up
or straight down. Note: Avoid driving crosswise ...