Hazard flasher control
The hazard flasher is located between the center air registers above the radio. The hazard flashers will operate whether the ignition is off or on.
• Press the flasher control and all front and rear direction signals will flash.
• Press the flasher control again to turn them off.
Use it when your vehicle is disabled and is creating a safety hazard for other motorists.
Note: With extended use, the flasher may run down your battery.
See also:
Transmission code designations
You can find a transmission code on
the Safety Compliance Certification
Label. The following table tells you
which transmission each code
represents.
...
Safety Compliance Certification Label
The National Highway Traffic Safety
Administration Regulations require
that a Safety Compliance
Certification Label be affixed to a
vehicle and prescribe where the
Safety Compliance Certific ...
Plastic (non-painted) exterior parts
Use only approved products to clean plastic parts. These products are
available from your authorized dealer.
• For routine cleaning, use Motorcraft Detail Wash (ZC-3-A).
• If tar or grease spots a ...