Removing the jumper cables

Removing the jumper cables  - Jump starting - Roadside Emergencies - Lincoln MKZ Owners Manual - Lincoln MKZ

Remove the jumper cables in the reverse order that they were connected.

Note: In the illustration, the vehicle on the bottom is used to designate the assisting (boosting) battery.

1. Remove the jumper cable from

1. Remove the jumper cable from the ground metal surface.

2. Remove the jumper cable on the negative (-) terminal of the booster vehicle’s battery.

3. Remove the jumper cable from the positive (+) terminal of the booster vehicle’s battery.

4. Remove the jumper cable from the positive (+) terminal of the disabled vehicle’s battery.

After the disabled vehicle has been started and the jumper cables removed, allow it to idle for several minutes so the engine computer can relearn its idle conditions.

    See also:

    Adjusting automatic transmission fluid levels
    Before adding any fluid, make sure the correct type is used. The type of fluid used is normally indicated on the dipstick and also in the Maintenance product specifications and capacities section ...

    Replacing front parking lamp/turn signal bulb
    For driver side replacement of the front parking lamp/turn signal bulb, do the following: WARNING: To reduce the risk of vehicle damage and/or personal burn injuries do not start your engine ...

    Settings/Vehicle Settings
    In this mode, you can configure different driver setting choices. Press the right arrow key (when in the Settings menu) to reach the listed modes below: Note: Some items are optional and may no ...