P (Park)


This position locks the transmission and prevents the front wheels from turning.
To put your vehicle in gear:
• Press the brake pedal
• Move the gearshift lever into the
desired gear
To put your vehicle in P (Park):
• Come to a complete stop
• Move the gearshift lever and
securely latch it in P (Park)
WARNING: Always set the parking brake fully and make sure the gearshift is latched in P (Park). Switch the ignition off and remove the key whenever you leave your vehicle.
See also:
Battery saver
The battery saver will shut off the lamps 10 minutes after the ignition
has been turned off.
• If the dome lamps were turned on using the panel dimmer control, the
battery saver will shut them ...
Unlocking and locking the doors using keyless entry
To unlock the driver’s door, enter the factory set 5-digit code or
your
personal code. Each number must be pressed within five seconds of each
other. The interior lamps will illuminate. Note: If ...
Gate Operator & Canadian Programming
During programming, your
hand-held transmitter may
automatically stop transmitting —
not allowing enough time for
HomeLink to accept the signal
from the hand-held transmitter.
After compl ...
