Changing the set speed

Changing the set speed  - Following a vehicle - Adaptive cruise control (ACC) (if equipped) - Driver Controls - Lincoln MKS Owners Manual - Lincoln MKS

There are three ways to change the set speed:

• Accelerate or brake to the desired speed and press and release the SET + or SET – control
• Increase or decrease the speed by holding either the SET + or SET – control, until the desired set speed is shown on the message center. The vehicle speed will gradually change to the selected speed.
• Increase or decrease the speed in increments of 1 mph (2 km/h) by briefly pressing the SET + or SET – control.

The ACC may apply the brakes to slow the vehicle down to the new set

The ACC may apply the brakes to slow the vehicle down to the new set speed. The set speed will display continuously in the message center while ACC is active.

    See also:

    Infant and/or toddler seats
    Use a safety seat that is recommended for the size and weight of the child. When installing a child safety seat: • Review and follow the information presented in the Airbag supplemental re ...

    Safety Practices
    WARNING: If your vehicle is stuck in snow, mud, sand, etc., do not rapidly spin the tires; spinning the tires can tear the tire and cause an explosion. A tire can explode in as little as three to ...

    Detection issues
    The radar sensor has a limited field of vision. In some situations it may not detect vehicles at all or detect a vehicle later than expected. Detection issues can occur: • When driving on a di ...