Switching to normal cruise control

Switching to normal cruise control - Using adaptive cruise control - Adaptive cruise control (acc) (if equipped) - Driver Controls - Lincoln MKX Owners Manual - Lincoln MKX

You can manually change from adaptive cruise control (ACC) to normal cruise control through the message center. Refer to Message center in the Instrument Cluster chapter. If normal cruise control is selected, the ACC indicator light will be replaced with a light. The gap setting will not be displayed, the system will not cruise control indicator light. The gap setting will not be displayed, the system will not automatically respond to lead vehicles and automatic braking will not be activated. The system will default to ACC when the engine is started.

WARNING: Normal cruise control will not brake due to slower vehicles. Always be aware of which mode is selected and apply the brakes when necessary.

    See also:

    Erasing HomeLink buttons
    To erase the three programmed buttons (individual buttons cannot be erased): • Press and hold the two outer HomeLink buttons until the indicator light begins to flash-after 20 seconds. Re ...

    Driving through water
    If driving through deep or standing water is unavoidable, proceed very slowly. Never drive through water that is higher than the bottom of the wheel rims (for cars) or the bottom of the hubs ...

    Replacing HID headlamp bulbs (if equipped)
    The low beam headlamps on your vehicle use a “high intensity discharge” source. These lamps operate at a high voltage. When the bulb is burned out, the bulb and starter capsule assembly must be re ...