Increasing speed while using speed control

To set a higher speed:
• Press and hold SET + until you get to the desired speed, then release.
You can also use SET + to operate the tap-up function. Press and
release SET + to increase the vehicle set speed in 1 mph (1.6 km/h)
increments.
• Use the accelerator pedal to get to the desired speed, then press and
release SET +.
See also:
Windshield wiper rainlamp feature
When the windshield wipers are turned on during daylight, and the
headlamp control is in the autolamp position, the exterior lamps will turn
on after a brief delay and will remain on until the wip ...
2007 Lincoln Navigator Review
Lincoln didn't redesign the new Navigator from the ground up, like Cadillac
did with its latest Escalade, but it sure did a number inside and out to make it
look completely different. The Navigato ...
BLIS and/or CTA on/off and disable operation
The BLIS and/or the CTA can be turned off via the message center. If
either the BLIS and/or the CTA is turned off, the systems will
automatically turn back on at the next ignition key cycle. When ...
