Hazard flasher control

The hazard flasher control is located on the instrument panel above the climate controls and below the audio controls. The hazard flashers will operate when the ignition is in any position or if the key is not in the ignition.
Press the flasher control and all front and rear direction signals will flash.
Press the flasher control again to turn them off. Use it when your vehicle is disabled and is creating a safety hazard for other motorists.
Note: With extended use, the flasher may run down your battery.

See also:
Lincoln drive control
Three distinct driving modes - Sport, Normal and Comfort - are easy to select
using the MKT's new Lincoln Drive Control and the shift lever.
"The new system coordinates the performance of mult ...
Reverse sensing system (if equipped)
The Reverse Sensing System (RSS) sounds a tone to warn the driver of
obstacles near the rear bumper when the R (Reverse) is selected and the
vehicle is moving at speeds less than 3 mph (5 km/h). T ...
Tire and Wheel Alignment
A bad jolt from hitting a curb or pothole can cause the front end of your
vehicle to become misaligned or cause damage to your tires. If your vehicle
seems to pull to one side when you’re driving, ...
