Check MyKey system status
The vehicle system check will provide the status of the following MyKey parameters:
• MYKEY MILES — This odometer only tracks mileage when a MyKey is used. If mileage does not accumulate as expected, then the MyKey is not being used by the intended user. The only way to reset this odometer to zero is by clearing MyKey . If this odometer is lower than the last time you checked, then the MyKey system has been recently cleared.
• # MYKEY(S) PROGRAMMED — Indicates how many MyKeys are programmed to the vehicle. Can be used to detect deletion of a MyKey .
• # ADMIN KEYS PROGRAMMED — Indicates how many admin keys are programmed to the vehicle. Can be used to detect if an additional spare key has been programmed to the vehicle.
Refer to Message center in the Instrument Cluster chapter for MyKey system warnings displays.
See also:
Central locking/Two-stage unlocking
When unlocking the driver door with the key, turn it once toward the
rear of the vehicle to unlock that door only, if the two-stage unlocking is
enabled. Turn the key a second time to unlock all d ...
Replacing backup lamp/supplemental tail lamp
The backup lamp and supplemental tail lamps are located in the trunk
lid. Follow the same steps to replace either lamp.
1. Make sure the headlamp switch is
in the off position and open trunk ...
Safety belt height adjustment
Your vehicle has safety belt height
adjustments at the front outboard
seating positions. Adjust the height
of the shoulder belt so the belt rests
across the middle of your shoulder.
To adju ...